Rip; The Rip Screen - ZyXEL Communications VMG1312-BX0D User Manual

Table 42 Policy Route: Add/Edit (Sheet 2 of 2)
LABEL
Source Port
Source MAC
Source
Interface
WAN Interface
Apply
Cancel

9.5 RIP

Routing Information Protocol (RIP, RFC 1058 and RFC 1389) allows a device to exchange routing
information with other routers.

9.5.1 The RIP Screen

Click Network Setting > Routing > RIP to open the RIP screen.
Figure 66 RIP
The following table describes the labels in this screen.
Table 43 RIP
LABEL
#
Interface
Version
Operation
Enabled
Apply
Chapter 9 Routing
DESCRIPTION
Enter the source port number.
Enter the source MAC address.
Type the name of the interface from which the matched traffic is sent.
Select a WAN interface through which the traffic is sent. You must have the WAN
interface(s) already configured in the Broadband screens.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
DESCRIPTION
This is the index of the interface in which the RIP setting is used.
This is the name of the interface in which the RIP setting is used.
The RIP version controls the format and the broadcasting method of the RIP
packets that the VMG sends (it recognizes both formats when receiving). RIP
version 1 is universally supported but RIP version 2 carries more information. RIP
version 1 is probably adequate for most networks, unless you have an unusual
network topology.
Select Passive to have the VMG update the routing table based on the RIP
packets received from neighbors but not advertise its route information to other
routers in this interface.
Select Active to have the VMG advertise its route information and also listen for
routing updates from neighboring routers.
Select the check box to activate the settings.
Click Apply to save your changes back to the VMG.
VMG1312-Bx0D User's Guide
138