Add/Edit Vpn Rule - ZyXEL Communications SBG3500-N000 User Manual

Chapter 20 IPSec VPN
Click VPN > IPSec VPN to display the Setup screen. This is a read-only menu of your IPSec VPN
rules (tunnels). Edit a VPN rule by clicking the Edit icon.
Note: The default IPsec rule Default_L2TPVPN cannot be disconnected on the VPN >
IPSec VPN > Monitor screen. However, you may disconnect L2TP tunnels in the
VPN > L2TP > Monitor screen.
Figure 118 VPN > IPSec VPN > Setup
The following table describes the fields in this screen.
Table 88 VPN > IPSec VPN > Setup
LABEL
Add New Entry
#
Enable
Name
Remote Gateway
Address
Local Gateway
Address
Remote Policy
Local Policy
Modify

20.4.1 Add/Edit VPN Rule

You can click the Add New Entry button or a policy's Edit icon in the IPSec VPN > Setup screen
to either add or edit a VPN policy.
Note: The SBG3500-N uses the system default gateway interface's WAN IP address as its
WAN IP address to set up a VPN tunnel.
258
DESCRIPTION
Click this button to set up VPN policies for a new tunnel.
This is the VPN policy index number.
This field displays whether the VPN policy is active or not.
This icon is turned on when the rule is enabled.
This field displays the identification name for this VPN policy.
This field displays the Secure Gateway Address of the IPSec router with which you're
making the VPN connection.
This field displays the IP address used by the SBG3500-N. If the selected interface is
not available, this field will display 0.0.0.0.
This field displays the remote policy.
This field displays the local policy.
Click the Edit icon to go to the screen where you can edit the VPN rule.
Click the Remove icon to remove an existing VPN rule.
SBG3500-N000 User's Guide