Honeywell SMV 3000 User Manual page 116

9.4 Replacing Electronics Module or PROM,
Procedure, continued
Table 28
104
Replacing Electronics Module or PROM, Continued
Step
3 Release retaining clip and unplug flex -tape and power connectors
from Main PWA underneath module. Unplug temperature input
connector from RTD measurement (Daughter) PWA underneath
module. Loosen two captive mounting screws on top of module, and
then carefully pull module from housing.
4 Remove screw holding molding/retaining clip to Main PWA and
remove molding/retaining clip from Main PWA.
SMV 3000 Transmitter User's Manual
Action
Electronics
Module
Flex-Tape
Temperature Input
and Power
Connector
Connectors
End-cap lock
Continued
22365
Continued on next page
1/99