Honeywell SMV 3000 User Manual page 185

Appendix B– Configuration Record Sheet,
2. Flow - PV4 - Configuration Section
(If using SMV 3000 for PV1, PV2 and PV3 measurement only, do not complete flow section.)
2a. Dynamic Flow Compensation Section
(If you are using a primary element that is not listed, use the Standard Flow Equation Section below.)
Flow Element Type:
Orifice - Flange Taps (ASME-ISO) D >/= 2.3 inches
Orifice - Flange Taps (ASME-ISO) 2 </= D </= 2.3
Orifice - Corner Taps (ASME-ISO)
Orifice - D and D/2 Taps (ASME-ISO)
Orifice - 2.5D and 8D Taps (ASME-ISO)
Venturi - Machined Inlet (ASME-ISO)
Venturi - Rough Cast Inlet (ASME-ISO)
Venturi - Rough Welded Sheet-Iron Inlet (ASME-ISO) _____ (Liquids only)
Nozzle (ASME Long Radius)
Venturi nozzle (ISA Inlet)
Leopold venturi
Gerand venturi
Universal Venturi Tube
Lo-Loss Venturi Tube
Preso Ellipse Ave. Pitot Tube
Material ____________
Bore Diameter (inches at 68 deg. F) ___________ (not required for Pitot Tube)
Design Temperature ______________ (not required for Pitot Tube)
Fluid State:
Flow Data: (obtained from Primary Element Sizing Sheet)
Design Pressure __________________ (required only for Gas applications)
Design Temperature ________________ (required only for Gas applications)
Design Density ___________________ (required only for Steam applications)
Standard Density __________________ (required only for Standard Volume equations)
Fluid Name:
Pipe Properties:
Isentropic Exponent:
2b. Standard Flow Compensation Section
(Standard equation should be used for any primary element not listed in Dynamic Flow Section above.)
Fluid State:
Fluid Name:
Flow Data: (obtained from Primary Element Sizing Sheet)
Normal Flowrate __________________
Normal Diff. Pressure_________________ Design Temperature ________________ (Gas applications only)
Design Density ___________________ (required only for Steam and Liquid applications)
Standard Density __________________ (required only for Standard Volume equations)
Flow Compensation:
1/99
_____
_____
_____
_____
_____ (Liquids only)
_____ (Liquids only)
_____ (Liquids only)
_____ (Liquids only)
_____ (Liquids only)
_____ (Liquids only)
_____ (Liquids only)
_____ (Liquids only)
_____ (Liquids only)
_____ (Specify 7/8", 1.25" or 2.25" Probe diameter)
Gas _____ Liquid _____
________________________________________________
Material __________ Pipe Schedule ______
_____________ (not required for Liquid applications or Pitot Tube)
Gas _____ Liquid _____
________________________________________________
Design Pressure
None ___ Full ___ Pressure Only ___
SMV 3000 Transmitter User's Manual
Continued
Steam _____
Pipe Diameter _________
Steam _____
_____________(Gas applications only)
Temperature Only___
Continued on next page
173