Honeywell SMV 3000 User Manual page 140

11.4 Diagnostic Messages,
Diagnostic Messages,
Table 32
continued
SMV Status SCT Status Message SFC Display Message TDC Status Message
Excess Zero Correct
2-1
PV1
Or
Zero Correction is Out of
Limits
4-1 Excess Zero Correct
PV2
8-1 Excess Zero Correct
PV3
9-1 Excess Zero Correct
PV4
9-5 In Cutoff PV4
5-4 Input Mode PV1 (DP)
128
Continued
Non-Critical Status Diagnostic Message Table, continued
STATUS TAG ID.# EX. ZERO COR PV1
EX. ZERO COR PV1
STATUS TAG ID.# EX. ZERO COR PV2
EX. ZERO COR PV2
STATUS TAG ID.# EX. ZERO COR PV3
EX. ZERO COR PV3
STATUS TAG ID.# EX. ZERO COR PV4
EX. ZERO COR PV4
STATUS TAG ID.# IN CUTOFF PV4
IN CUTOFF PV4
STATUS TAG ID.# INPUT MODE PV1
INPUT MODE PV1
SMV 3000 Transmitter User's Manual
Possible Cause
ZERO correction factor is outside
acceptable limits for PV1 range.
Could be that transmitter was in
input or output mode during a
CORRECT procedure.
ZERO correction factor is outside
acceptable limits for PV2 range.
Could be that transmitter was in
input or output mode during a
CORRECT procedure.
ZERO correction factor is outside
acceptable limits for PV3 range.
ZERO correction factor is outside
acceptable limits for PV4 range.
Calculated flow rate is within
configured low and high limits for
PV4 low flow cutoff.
Transmitter is simulating input for
PV1.
What to Do
• Verify calibration.
• If error persists, call the
Solutions Support Center
• Verify calibration.
• If error persists, call the
Solutions Support Center
• Verify calibration.
• If error persists, call the
Solutions Support Center
• Verify calibration.
• If error persists, call the
Solutions Support Center
Nothing – wait for flow rate to
exceed configured high limit.
Verify that flow rate is in cutoff.
Exit Input mode:
SCT – Press "Clear Input Mode"
button on the DP InCal tab.
SFC – Press [ ], [ ], and
SHIFT INPUT
[ ] keys.
CLR
1/99