SERVICE MANUAL
8.4
Wheels
WARNING!
After ANY adjustments, repair or service and before use, make sure all attaching hardware
is tightened securely - otherwise injury or damage may result.
● Before performing any maintenance, adjustment or service verify that ON/OFF switch on the
joystick is in the OFF position.
8.4.1
Engaging/Disengaging motor release lever
Note
Engaging/Disengaging motor release lever is decribed in the user manual.
8.4.2
Removing/Installing the front/rear casters
Note
Front and rear casters are replaced in the same manner.
When replacing the front/rear casters, it is necessary to brace the caster to prevent spinning.
Requirements:
● 2 x 16 mm open-ended or box spanners
Removing the front/rear casters:
●
Remove the mounting screw (4), two spacers (3), and locknut (1) that secure the caster (2) to
the fork (5).
●
Remove the caster (2).
Installing the front/rear casters:
●
Secure new/existing caster (2) to fork (5) with mounting screw (4), two spacers (3), and
locknut (1).
●
Torque locknut (1) to 10 ft‐lbs (14 Nm) (120 in‐lbs (13,56 Nm)).
●
Loosen the locknut (1) 1/8 of a turn.
●
Move the caster (2) side to side.
50
®
Invacare
- PRONTO M41