SECTION 10—SHROUD AND WHEELS
Base Frame
Engaging/Disengaging Motor Release Lever
DO NOT engage or disengage the motor release lever until the On/Off switch on
the joystick is in the Off position.
Ensure both motor release levers are fully engaged before driving the wheelchair
NOTE: For this procedure, refer to FIGURE 10.2 on page 51.
NOTE: The motor lock disengagement/engagement allows freewheeling or joystick controlled
operation. Freewheeling allows an attendant to maneuver the wheelchair without power.
1. Locate the motor release handles on the motors protruding through the shroud on the
front of the wheelchair behind the footboard.
2. Perform one of the following:
• To Disengage the Motor Release Levers ‐ Push the motor lock lever down.
NOTE: This allows the wheelchair to freewheel for pushing, if necessary.
NOTE: It may be necessary to rock the wheels slightly until the motor release lever disengages.
• To Engage the Motor Release Levers ‐ Pull the motor lock handles up.
NOTE: This allows the motors to drive the wheels.
Pronto® M41 with SureStep®
Center Hole in
Shroud
NOTE: Joystick
cable and connector
not shown.
FIGURE 10.1 Removing/Installing the Shroud
WARNING
CAUTION
DETAIL "A"
Shroud
Base Frame
50
Shroud
Seat Post
Motor Release
Handles
Part No. 1143206