Preliminary Steps; Removing The Tpm; Re-Installing The Tpm - Fujitsu PRIMERGY BX920 S3 Upgrade And Maintenance Manual

10.3.3.2 Preliminary steps

Before replacing the TPM, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the desired server blade as described in section
defective server blade" on page
Ê Shut down the server blade as described in section
server blade" on page
Ê Remove the server blade from the system unit as described in section
"Removing the server blade from the system unit" on page
Ê Open the server blade as described in section
on page 58.

10.3.3.3 Removing the TPM

Ê Remove the TPM as described in section

10.3.3.4 Re-installing the TPM

Figure 100: TPM spacer
The TPM spacer is already present on the system board.
Ê Re-install the TPM as described in section
BX920 S3
70.
54.
55.
Upgrade and Maintenance Manual
System board components
47.
"Opening the server blade"
"Removing the TPM" on page
"Installing the TPM" on page
"Disabling BitLocker
"Opening the rack
"Locating the
"Shutting down the
57.
232.
227.
237