Fujitsu PRIMERGY BX920 S3 Upgrade And Maintenance Manual page 142

Expansion cards and backup units
Ê After replacing a network controller in a server blade running Linux OS,
update its MAC address in the related NIC definition file as described in
section "Updating the NIC configuration file in a Linux environment" on
page 94.
Ê Update the firmware as described in section
firmware" on page
Ê In order to configure a mezzanine card that has been installed or replaced,
the card's Option ROM has to be enabled in the system board BIOS. For
SAN / iSCSI boot the card's Option ROM has to be enabled permanently. If
applicable, proceed as described in section
page 85.
Ê Enable boot watchdog functionality as described in section
watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing / upgrading LAN/CNA controllers" on page
142
84.
89.
96.
Upgrade and Maintenance Manual
"Updating mezzanine card
"Enabling Option ROM scan" on
"Enabling boot
99.
"Enabling
BX920 S3