Multioutput Power Supply Backplane - HP ProLiant DL160 Gen8 Maintenance And Service Manual

Remove the power supply module.
4.
WARNING:
power supply blank to cool before touching it.
To replace the component, reverse the removal procedure.

Multioutput power supply backplane

To remove the component:
Power down the server (on page 27).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the server from the rack (on page 28).
3.
Remove the access panel
4.
Remove the processor air baffle
5.
Remove the PCI riser cage
6.
Remove the fan cables, front IO (Input/Output) cables, FBWC cable, power supply cables, and
7.
Mini-SAS cables.
Remove the system board tray:
8.
Loosen the two thumbscrews.
a.
To reduce the risk of personal injury from hot surfaces, allow the power supply or
("Access panel" on page 29).
("Processor air
("PCI riser cage" on page 45).
baffle" on page 30).
Removal and replacement procedures 31