Removing The 2P Pass-Through Performance Board - HP ProLiant DL560 Gen10 User Manual

Removing the 2P pass-through performance board

Procedure
1. Power down the server (Power down the server on page 38).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (Extend the server from the rack on page 38).
• Remove the server from the rack (Removing the server from the rack on page 39).
4. Remove the access panel (Removing the access panel on page 40).
5. Remove the pass-through board.
48 Removing the 2P pass-through performance board