EPSON EPL-N2050
4.2.56 Harness Assy Fuser-M
4.2.56.1 Removal
1. Remove the Cover Assy Front (Section 4.2.3).
2. Remove the Cover Front L/H (Section 4.2.5).
3. Remove the Cover Rear (Section 4.2.12).
4. Remove the Fuser Assy (Section 4.2.55).
5. Remove the Cover Assy I/F (Section 4.2.2).
6. Remove the Cover Left (Section 4.2.1).
7. Remove the Cover Assy Top (Section 4.2.7).
8. Remove the Chute MBF Assy (Section 4.2.30).
9. Remove the Shaft 14 (Section 4.2.51).
10. Remove the Gear 14 (Section 4.2.51).
11. Remove the P/H Assy (Section 4.2.42).
12. Remove the Chute Trans Assy (Section 4.2.54).
13. Remove the Plate Assy Left (Section 4.2.70).
14. Remove the CRU Top Guide Assy (Section 4.2.65).
15. Remove the Plate Handle (Section 4.2.72).
16. Remove the PWBA MCU (Section 4.2.83).
17. Remove the Motor Assy Main (Section 4.2.68).
18. Remove the PWBA PS (Section 4.2.85).
19. Remove the Gear Assy Drive (Section 4.2.67).
20. Unplug the connector (P/J262) on the PWBA HVPS from the printer.
21. Remove the one screw securing the Housing HVPS together with PWBA
HVPS from the printer.
22. Remove the Housing HVPS together with PWBA HVPS from the printer.
23. Unplug the connector (P/J34) from the PWBA MCU.
24. Unplug the connector (P/J11) from the PWBA PS.
Disassembly and Assembly
25. Pull the Harness Assy Fuser-M from the left hole in the printer.
26. Remove the two screws securing the Harness Assy Fuser-M to the printer.
27. Remove the Harness Assy Fuser-M from the printer.
Figure 4-74. Removal of Harness Assy Fuser-M
Disassembly and Assembly
Revision B
170