Station Programming Instructions - Panasonic KX-TD500 User Manual

2.1

Station Programming Instructions

Station Programming allows you, the proprietary telephone (PT) users, to program certain
features from your telephone individually. To program, you need to switch your
telephone to the Station Programming mode. During programming mode, your telephone
is in the busy condition to both inside and outside callers. If you want to make a normal
call handling operation, you must finish the programming mode.
Programming Mode Display
When you enter into the Station Programming mode, the display shows the following
message as the initial programming mode;
We recommend a PT with display for Station Programming to avoid mis-operation.
The display also gives you helpful or stored data information related to your programming
steps. In this section, we note the display example in the programming steps, if required.
You can also refer to the "Display Examples" in the Appendix (Section 6).
Entering Station Programming mode
PT
Be sure that the telephone is idle and on-hook.
PROGRAM
Press PROGRAM.
• The STORE indicator lights.
• If 99 is not dialed within 5 seconds after the PROGRAM button is
• If there is no entry within one minute, the Station Programming mode
Exiting Station Programming mode
PT
When the display shows the initial programming mode;
PROGRAM
Press PROGRAM.
• To exit the Station Programming mode, press PROGRAM. You are in
the call handling mode.
2-2
Station Programming
PT-PGM Mode
9
pressed, the Station Programming mode is canceled.
<PT Display Example>
PT-PGM Mode
is canceled and normal call handling mode resumes automatically.
9
Dial 99.
– Initial programming
display