Panasonic KX-TD500 User Manual page 44

2.1 Station Programming Instructions
Confirming the assigned function data
— Be sure that you are in the Station Programming mode: Press [PROGRAM] [9] [9].
PT
program access number
Enter the program access number.
• Enter the program access number* as follows.
- 1: Preferred Line Assignment — Outgoing
- 2: Preferred Line Assignment — Incoming
- 3: Full One-Touch Dialing Assignment
- 4: Intercom Alert Assignment
- 5: Call Waiting Tone Type Assignment
- 6: Self-Extension Number Confirmation
- 7: Live Call Screening Mode Set
-81: Initial Display Selection
-82: Bilingual Display Selection
- 9: Handset/Headset Selection
-01: Remote Station Look Control (— Operator / Manager only)
-02: Control of Call Log Incoming, Log Lock (— Operator / Manager only)
-03: Live Call Screening Password Control (— Operator / Manager only)
- #: Station Programming Data Default Set
• The display shows the programmed data.
<PT Display Example>
When you press [5], the display shows:
C.W. Tone1
— To exit the Station Programming mode: Press [PROGRAM].
— If you wish to change the data, follow the programming procedure explained in this
section.
* A programming access number is required to program/confirm the function data by Station Programming.
†: Available when the Digital Super Hybrid System is connected to a Digital
Proprietary Telephone capable Panasonic Voice Processing System (one
that supports digital proprietary telephone integration; e.g. KX-TVS100).
HOLD
Press HOLD (END).
• The display shows the initial programming mode.
†
(— The Call Waiting tone is currently programmed to Tone 1.)
Station Programming
2-3