Programming; Programming Instructions - Panasonic KX-NCP500 Pt Programming Manual

2.1.1 Programming Instructions

2.1 PT Programming
2.1.1 Programming Instructions
Required Telephone/Extension
PBX settings can be customized through system programming by using a multi-line display Digital Proprietary
Telephone (DPT) or IP Proprietary Telephone (IP-PT), such as the KX-NT343 or KX-NT346. Multi-line display
Analogue Proprietary Telephones (APTs) are not supported. To access system programming, the Class of
Service (COS) assigned to the PT's extension must be programmed to allow system programming, or the PT
must be connected to the lowest-numbered port on the card installed in the lowest-numbered slot.
Only one system programming session can be performed at a time. This means that only one user can access
system programming at a time, whether through a PT or PC.
For a list of characters that can be entered during system programming, see Section 1.1.3 Entering
Characters.
Buttons and Functions
KX-NT300/KX-DT300
SHIFT
PAUSE
14 PT Programming Manual
Fixed Buttons
KX-NT136/KX-T7600
SHIFT
PAUSE
HOLD
AUTO ANS
MESSAGE
MUTE
KX-T7200/KX-T7400
*1
REDIAL
SP-PHONE
FWD/DND
CONF
AUTO DIAL
STORE
—
SHIFT
PROGRAM PAUSE
HOLD
AUTO ANSWER MESSAGE
MUTE
Function
PREVIOUS
NEXT
(Page up)
(Page down)
ENTER
Back to Previous Menu
(CANCEL)
SHIFT
PROGRAM
END
SELECT
Document Version 2012-10