Placement Of Cis Unit In Position For Transportation (Function Code 06); Adf Performance Test (Function Code 08) - Brother DCP-7030 Service Manual

1.4.3 Placement of CIS Unit in Position for Transportation
(Function code 06)
<Function>
This function is to move the CIS unit in position for transportation located at the left end.
When you fix the machine and check its operation, you need to perform this function last
before packing and shipping.
Note :
Please instruct end users to perform this function if possible before packing and shipping
their FAX machine to a sales agent or a service dealer for the purpose of repair. (For the
procedure to allow users to perform maintenance modes, refer to
User-accessible Maintenance Mode"
<Operating Procedure>
(1) MFC7840W/7840N/7450/7440N/7340/7320
Press in order the 0 and 6 buttons in the initial stage of the maintenance mode.
DCP7045N/7040/7030
Press the
OK button.
The CIS unit moves to the designated position for transportation located at the left side.
The "MAINTENANCE 06" is displayed until the CIS unit is placed in position. When the
scanner unit is placed in the position, the "SCAN LOCK" appears on the LCD.
(2) Press the Stop/Exit button. The machine beeps for one second and returns to the initial
stage of the maintenance mode.
Note :
• If it is impossible to move the CIS unit in position for transportation, or if this function is
performed while a scanning error is occurring, the "SCAN LOCK ERROR" appears on the LCD.

1.4.4 ADF Performance Test (Function code 08)

<Function>
The machine counts the documents fed by the automatic document feeder (ADF) and
displays the count on the LCD for checking of the ADF performance.
<Operating Procedure>
(1) Set documents. (Allowable up to the ADF capacity.)
The "DOC. READY" will appear on the LCD.
(2) MFC7840W/7840N/7450/7440N/7340/7320
Press in order the 0 and 8 buttons.
DCP7045N/7040/7030
Press the
OK button.
While counting the documents, the machine feeds them in and out, displaying the
current count on the LCD as shown below.
ADF CHECK P.01
(3) Press the Stop/Exit button so that the machine beeps for one second and returns to the
initial stage of the maintenance mode.
in this chapter.
or button. "MAINTENANCE 06" appears on the LCD, and then press the
or button. "MAINTENANCE 08" appears on the LCD, and then press the
Current count (1st page in this example)
5-6
"1.2 How to Enter the End
Confidential