Brother DCP-7030 Service Manual page 36

■ Error code 9F
No paper
Reload paper, then press start.
Paper empty (It is detects by the registration front sensor)
User Check
• Replenish the paper in the paper tray.
Step
Registration front actuator
1
catching in some position
Registration front sensor PCB
2 harness connection failure
Registration front sensor PCB
3
failure
4 Main PCB failure
■ Error code A1
Cover is open
Close the Front Cover.
Front cover open
User Check
• Close the front cover.
Step
Harness connection failure of
1
cover sensor harness ASSY.
Cover sensor harness ASSY
2
failure
3 Main PCB failure
■ Error code A2
Document Jam.
Clear the scanner jam, then press the Stop Key.
The document is too long. (During scanning, 90 cm or longer of a document is detected.)
User Check
• Check if the document is jammed in the ADF. If it is jammed, remove it.
Step
Document rear actuator not
1 operating smoothly or catching in
some position.
Cause
Cause
Cause
1-18
Remedy
Re-assemble the registration front actuator.
Check the harness connection of the
registration front sensor PCB and
reconnect it.
Replace the registration front sensor PCB.
Replace the main PCB ASSY.
Remedy
Check the harness connection of the cover
sensor harness ASSY, and reconnect it.
Replace the cover sensor harness ASSY.
Replace the main PCB ASSY.
Remedy
Ensure smooth operation and that there is
no catching of document rear actuator.
Confidential