8.15 NCU PCB
(1) Remove the Screw pan (S/P washer) M3.5x6 screw, and then remove the FG harness
from the NCU shield.
(2) Remove the two Taptite bind B M4x12 screws, and then remove the NCU shield from the
Joint cover.
Taptite bind B M4x12
(3) Turn over the NCU housing.
(4) Remove the two Taptite cup S M3x6 SR screws, and then remove the NCU PCB from
the NCU housing.
(5) Disconnect the Connector from the NCU PCB, and then pull out the Connector from the
NCU housing.
Connector
Screw pan (S/P washer)M3.5x6
Taptite bind B M4x12
NCU shield
2
Fig. 3-56
Taptite cup S M3x6SR
4
5a
5b
Fig. 3-57
3-58
FG harness
1
Joint cover
NCU PCB
NCU housing
3
Confidential