Connecting To The Network Port; Figure 2-15 Network Connector - Honeywell HRXD9 User Manual

Installation
Caution
Caution

Connecting to the Network Port

The DVR can be networked using the 10/100Mb Ethernet connector. Connect a Cat5
cable with an RJ-45 jack to the DVR connector. The DVR can be networked with a
computer for remote monitoring, searching, configuration and software upgrades. See
Chapter 3, Configuration
Caution
Rev 1.00
Do NOT connect or disconnect SCSI devices while the DVR
power is on. The DVR must be powered down to connect or
disconnect SCSI devices. Power up SCSI devices so they are
ready for operation before powering up the DVR. Power down
SCSI devices after powering down the DVR and then disconnect
SCSI devices.
If the SCSI device is shut down while the device is operating, the
DVR system might not operate normally.
Figure 2-15 Network Connector
for configuring the Ethernet connections.
The network connecter is not designed to be connected with
cable or wire intended for outdoor use.
13 Document 900.0856
12/06