Figure 3-34 Notification Callback Setup Screen - Honeywell HRXD9 User Manual

Configuration
Highlight the box beside Recipient and enter the recipient's e-mail address. Use the
virtual keyboard to enter the e-mail address.
Highlight the Callback tab, and the Callback screen displays.
Highlight LAN and press
you can change the IP addresses.
Highlight the IP Address box that you want to change and press
address of the computer you want contacted during an event. You can enter up to five
IP addresses.
Highlight the box beside Retry and enter the number of times you would like the DVR
to try contacting the computer. You can select from 1 to 10 retries.
If the modem was enabled in the Network screen, you can set up the DVR to contact a
computer running RAS. Highlight Modem and press
When Modem is turned On you can enter a telephone number.
Highlight the box beside Remote Server Phone Number and enter the telephone
number of the computer running RAS.
Highlight the box beside Outside Line Call and enter any numbers that must be dialed
for an outside line for your telephone system; for example, 9.
Highlight the box beside Callback Phone Number and enter the telephone number of
the DVR.
You can save your Notification changes by highlighting Save and pressing
Selecting Cancel exits the screen without saving the changes.
Rev 1.00
Figure 3-34 Notification Callback Setup Screen
to toggle between On and Off. When LAN is turned On
45
. Enter the IP
to toggle between On and Off.
Document 900.0856
.
12/06