Configuration
You can adjust the display dwell time by highlighting the box beside Interval and
pressing
Highlight Event Monitoring On and press
Off. When it is On, the DVR will display the camera associated with the event when an
event occurs.
Highlight the Spot Monitor tab to switch to the Spot Monitor screen.
You can define which cameras display sequentially on the Spot Monitors. Highlight the
box in the Channels column for the desired Spot Monitor and press
You can save your Display settings by highlighting Save and pressing
Cancel exits the screen without saving the changes.
Remote Control Screen
Highlight Remote Control in the Devices menu and press
setup screen allows you to select a port and make correct settings for a remote
keyboard.
Rev 1.00
Note
Sequence cannot be used in the 4x4 display mode of the
16-channel, and the 3x3 mode of the 9-channel DVR.
. You can select dwell intervals ranging from 1 second to 1 minute.
Figure 3-46
Spot Monitor Screen
. Pressing
53
toggles between On and
.
. Selecting
. The Remote Control
Document 900.0856
12/06