Figure 3-78 System Event Actions Screen - Honeywell HRXD9 User Manual

Configuration
The DVR can be set to react to system events. System events can be associated with
an Alarm-Out connector, sound the DVR's internal buzzer, and/or notify a number of
different devices.
Highlight the Alarm-Out box beside the desired event (Check Recording, Check
Alarm-In, Disk Almost Full, Disk Full, Disk Bad, Disk Temperature, or Disk
S.M.A.R.T.), and press
many Alarm-Outs with the Event as you wish. If the DVR detects that event, it triggers
output signals on all the associated Alarm-Out connectors. You can also have the
DVR's internal buzzer sound if an event is detected.
Highlight the Notify box beside the desired event (System, Panic Record, Check
Recording, Check Alarm-In, Disk Almost Full, Disk Full, Disk Bad, Disk
Temperature, or Disk S.M.A.R.T.), and press
Off by highlighting Notification and pressing
On and Off by highlighting that item and pressing
accept your changes.
Rev 1.00
Figure 3-78 System Event Actions Screen
. A list of Alarm Outputs appears. You can associate as
Note Alarm-Out action cannot be set to System and Panic Record
events.
Note Mail notify is the only option available for the System event.
Note For the Notify action to work, the DVR should be registered in the
RAS (Remote Administration System).
. You can toggle the entire list On and
. You can toggle the individual items
. Highlight OK and press
77
to
Document 900.0856
12/06