Figure 3-7 Upgrade Screen - Honeywell HRXD9 User Manual

Configuration
Highlight the Site box and press
enter a Site Name.
Once you have entered your title, highlight OK and press
Highlight the box beside System ID and press
it and using the Up and Down arrow buttons to increase and decrease the number from
0 to 99.
Highlight the box beside Language and press
available languages. Highlight the desired language and press
The box beside Version displays the software version of the DVR.
To upgrade the software, connect a USB device containing the upgrade package file to
the DVR. Highlight Upgrade... and press
screen displays the upgrade package file names that are available. The .rui indicates
that the file is for software upgrades and .ofi indicates that the file is for optical drive
firmware upgrades. Select the desired file and press
pressing
pressing
package file is not installed on the DVR properly, you will get an error message. The
system restarts automatically after completing the upgrade.
Rev 1.00
Note The System ID number is used to identify the unit when it is
connected with other DVRs through the RS485 port. You cannot
use the same ID number for two or more DVRs that are in the
same RS485 network. It is possible to have multiple DVRs with
System ID 0 that are in the same area as long as they are not
part of an RS485 network. If this is the case, all will be controlled
at the same time when using the infrared remote control.
will install the selected software package. Highlighting Cancel and
will close the window without upgrading the software. If the upgrade
Figure 3-7 Upgrade Screen
Note Upgrade will be deactivated if the hard disk drive has not been
formatted as it requires the space for temporary files when
upgrading the system.
. A virtual keyboard appears that you can use to
. Change the number by highlighting
. A drop-down menu displays the
. The Upgrade screen appears. The
24
.
.
. Highlighting Install and
Document 900.0856
12/06