Table of Contents
Advertisement
Configuration
Highlight the Main Monitor tab to switch to the Sequence screen.
You can adjust the display dwell time for each camera displayed on the main monitor.
Highlight the box beside Mode and press
and Cameo Sequence.
Pressing SEQUENCE causes the DVR to sequence cameras, and the DVR can
sequence cameras in two modes: Full and Cameo. In the Full mode, the DVR
sequences through the cameras and displays them full screen. In the Cameo mode, the
bottom right window in a multi-screen format sequences through the cameras.
You can define the screen layout in a variety of formats and set the DVR to sequence
through the different screen layouts (pages) so that all the cameras will be displayed.
You can also set up the DVR to display one camera or a group of cameras all the time
while cycling through the remaining cameras in a Cameo window. This can be done
with one camera displayed full screen while displaying the cameo window as a PIP
(picture in picture), or displaying the cameras in a grid pattern with the bottom right
window as the cameo.
Rev 1.00
Figure 3-44
OSD Margin Screen
Figure 3-45
Main Monitor Screen
Note
Any cameras that are Off, have lost video or are set to Covert
(unless the user has authority to view covert cameras) will be
excluded from the Cameo sequence.
. You can select between Full Sequence
52
Document 900.0856
12/06
Advertisement
Table of Contents
