Messages And Signals - Sharp UX-385 Operation Manual

Messages and Signals

Messages and Signals
Display messages.
A.M. OFF HOOK
CHECK PAPER SIZE
COVER OPEN
DOCUMENT JAMMED
FAX RX IN MEMORY
FILM END
FUNCTION MODE
LINE ERROR
92
When the fax is in A.M. reception mode, this message
appears when the handset of an answering machine (or
extension phone) connected to the fax has been lifted.
An incorrect size of paper has been loaded in the paper
tray. Remove the paper and load A4-size paper.
The print compartment cover (under the operation
panel) is open. Open the operation panel (grasp the top
and pull toward you), and then press down firmly on both
sides of the print compartment cover to close it.
The original document is jammed. See the following
section, Clearing Paper Jams.
A fax has been received in memory because the
imaging film needs replacement, you have run out of
printing paper, or the paper is jammed. After you fix the
problem, press the START/MEMORY key to print out
the fax.
The imaging film may need replacement. Check the film
and replace if necessary.
The FUNCTION key has been pressed.
Transmission or reception was not successful. Press
STOP to clear the message, and then try again. If the
error persists, see Line Error in Problems and Solutions
in this chapter.