Messages And Signals - Sharp UX-B30 Operation Manual

Messages and Signals

Display messages
ADD PAPER & /
PRESS START KEY
(alternating messages)
A.M. OFF HOOK
CHANGE CARTRIDGE
CHECK CARTRIDGE
DOCUMENT JAMMED
FAX RX IN MEMORY
FUNCTION MODE
INK NEAR EMPTY
Check the printing paper. If the tray is empty, add
paper and then press
tray, make sure it is inserted correctly (take out the
stack, align the edges evenly, and then reinsert it in
the tray) and then press
When the fax is in A.M. reception mode, this
message appears when the handset of an answering
machine (or extension phone) connected to the fax
has been lifted.
This message appears after you install or replace the
print cartridge (see page 19).
The print cartridge is missing and must be installed,
or is not installed correctly.
The original document is jammed. See the following
section, Clearing Paper Jams. Document jams will
occur if you load more than 10 pages at once or load
documents that are too thick (see page 37). The
document may also jam if the receiving machine
doesn't respond properly when you attempt to send a
fax.
A fax has been received in memory because the print
cartridge needs replacement, you have run out of
printing paper, or the paper is jammed. The fax will
print out automatically when the problem is fixed.
has been pressed.
The cartridge is nearly empty (approximately one
eighth of the ink remains).
Messages and Signals
. If there is paper in the
.
93