Messages And Signals - Sharp UX-A460 Operation Manual

Messages and Signals

Messages and Signals
Display messages
Note: If you have turned on the Caller ID function, see page 73 for display
messages related to Caller ID.
ADD PAPER & /
PRESS START KEY
(alternating messages)
A.M. TRANSFER
CHECK FILM/
CHECK COVER/
CHECK PAPER JAM
(alternating messages)
CHECK PAPER SIZE
DOCUMENT JAMMED
FAX RX IN MEMORY
FUNCTION MODE
90
Check the printing paper. If the tray is empty, add
paper and then press the START/MEMORY key. If
there is paper in the tray, make sure it is inserted
correctly (take out the stack, align the edges evenly,
and then reinsert it in the tray) and then press the
START/MEMORY key.
The answering machine's transfer function has been
turned on (see page 33).
These alternating messages appear when there is a
problem in the print compartment that prevents
printing. Check to see if the imaging film is not loaded
properly or if it has been used up and needs
replacement. Make sure the operation panel is
completely closed (press down on both sides). If a
paper jam has occurred, clear the jam as explained in
the following section, Clearing Paper Jams .
An incorrect size of paper has been loaded in the
paper tray. Remove the paper and load A4-size
paper.
The original document is jammed. See the following
section, Clearing Paper Jams . Document jams will
occur if you load more than 10 pages at once or load
documents that are too thick (see page 45).
A fax has been received in memory because the
imaging film needs replacement, you have run out of
printing paper, or the paper is jammed. The fax will
print out automatically when the problem is fixed.
The FUNCTION key has been pressed.