Sharp UX-385 Operation Manual page 80

Option Settings
Setting 15: FLASH SELECT
If you are on a PBX and have set the PBX Select setting to "Flash", use this setting
to select the Flash time length. If your PBX line is a normal telephone line, press 1 to
select SHORT TIME. If your PBX line is an ISDN line, press 2 to select LONG TIME.
Initial setting: 1
FUNCTION
4
SHORT
LONG
or
1 2
Setting 16: FAX SIGNAL RECEIVE
Your fax is will automatically begin reception if you hear a high-pitched fax tone after
answering a call. If you use a computer fax modem on the same line, you must turn
this function off in order to prevent your fax from mistakenly attempting to receive
documents sent from the computer fax modem. Press 1 to turn the function on, or 2
to turn it off.
Initial setting: 1
FUNCTION
4
YES NO
or
1 2
Setting 17: JUNK NUMBER CHECK
Press 1 to prevent reception from fax numbers entered in the Anti Junk Number
List. Press 2 to allow reception from all numbers.
Initial setting: 2
FUNCTION
4
YES NO
or
1 2
78
until display
Press
shows:
FAX SIGNAL RX
until display
Press
shows:
JUNK FAX # CHECK
until display
Press
shows:
POLLING
FLASH SELECT
STOP
FAX SIGNAL RX
STOP
JUNK FAX # CHECK
STOP