Sharp UX-385 Operation Manual page 79

Setting 14-1: PBX CONNECTION
Press 1 (YES) if the machine is connected to a PBX. Press 2 (NO) if it is connected
to a regular public line.
Initial setting: 2
FUNCTION
4
YES NO
or
1 2
Setting 14-2: PBX SELECT
This sets the mode used for connecting calls from a PBX to an outside line. Refer to
your PBX manual or consult your supplier for the correct setting. Make the selection
by entering a number from 1 or 2 as follows:
1:ID
2:FLASH
Initial setting: 1
(If you select 1, Setting 14-3 will subsequently appear in the display. If you select 2,
Setting 15 will appear.)
Setting 14-3: PBX ID NO.
If you set Option Setting 14-2 to 1 (PBX ID digit mode), use this setting to enter your
PBX ID number (maximum of 3 digits). Press the START/MEMORY key when
finished.
Initial Setting: 0
(Note: The ID number is automatically dialled for access to the public line when
Rapid Key or Speed Dialling is used. Do not store it as part of the number when
storing a Rapid Key or Speed Dialling number.)
until display
Press
shows:
(If you select 1, Setting 14-2 will
subsequently appear in the display. If
you select 2, Setting 15 will appear.)
Option Settings
PBX CONNECTION
77