Messages And Signals - Sharp UX-40 Operation Manual

al l - ux40. book
Downloaded from: http://www.usersmanualguide.com/
Page 94 Thur s day, Novem ber 18, 1999

Messages and Signals

Messages and Signals
Display messages
Note: If you have turned on the Caller ID function, see Caller ID in Chapter 7
for display messages related to Caller ID.
COVER OPEN
DOCUMENT JAMMED
FUNCTION MODE
LINE BUSY
LINE ERROR
NO DATA
NO # STORED
OFF HOOK
ON HOOK DIAL
OUT OF PAPER
94
2: 35 PM
The operation panel is open. Close it.
The original document is jammed. See the following
section, Clearing Paper Jams.
The FUNCTION key has been pressed.
This appears if you attempt to send a fax by
automatic dialing and the line is busy or the receiving
fax machine doesn't answer (even after automatic
redialing). Press the STOP key to clear the message.
Transmission or reception was not successful. Press
the STOP key to clear the message and then try
again. If the error persists, see Line Error in Problems
and Solutions in this chapter.
This appears if you attempt to search for an
automatic dialling number when none have been
stored.
You have tried to dial or clear a Rapid Key or Speed
Dial number that hasn't been programmed (a full
number hasn't been assigned to it).
This appears if you forgot to replace the handset after
using it to dial and send a fax. Replace the handset or
press the STOP key to clear the message.
The SPEAKER key has been pressed and the fax
machine is waiting for you to dial.
You have run out of thermal paper. Load a new roll of
thermal paper as explained in Loading the Thermal
Paper in Chapter 1.