Avaya ESS User Manual page 160

Maintenance
status ess port-networks field descriptions (continued)
Field
Pri / Sec State
Cntl Clus ID
160 Avaya Enterprise Survivable Servers (ESS) Users Guide
Description
The state of the Primary and Secondary IPSIs whose locations are shown
in the Pri / Sec Loc field.
actv-aa = the IPSI is both active and is controlling the Port Network
●
(hosting the Arch Angel).
active = the IPSI is active but not controlling the Port Network. In this
●
case the Port Network may not be controlled or is being controlled
through an Expansion Interface (EI).
standby = the IPSI is in standby mode (duplex Port Network
●
connectivity).
unknown = the IPSI state is unknown
●
blank = there is no IP Server Interface.
●
Control Cluster IDentifier. The cluster identifier of the server that was last
known to be controlling this Port Network through this IPSI. If there are
duplicate IPSIs in this Port Network, they should show the same Cluster ID
Cluster ID (1 - 999)
●
* (asterisk)
●
- The media server where status ess port-networks is run
cannot connect to the IP Server Interface in this Port Network. This
may be because:
the IPSI is being reset
the IPSI rejected the connection request from the media server,
perhaps because it is already connected to its limit (8) of media
servers.
- The controlling Cluster ID reported for the IPSI is not known to the
media server (in its translations) where status ess
port-networks was run.
blank
●
- There is no IPSI in this Port Network.
- There is no controlling media server.
3 of 4