Avaya ESS User Manual page 136

Enterprise Survivable Server Conversions
8. Configuring the media server via the Maintenance Web Interface causes a reset to be
executed. While this is normal, it is not sufficient to notify all of the non Avaya
Communication Manager processes of the new Cluster ID.
From the active media server command line interface use the following command to notify
all processes of the new parameters:
server -z
Then, from the SAT interface on the active media server, execute:
reset system 4.
9. For
S8700 | 8710
Release Server command on the Maintenance Web Interface.
Wait for the license file to be file synced from the active media server to the standby. This
can be verified by using the bash command statuslicense -v repeatedly until the
Module ID is updated. Once the Module ID is updated execute:
server -z
to inform all processes of the new Module ID.
10. Verify that the new Main server has the latest translations available. If not, restore the
translations from the latest backup.
11. Remove the translations for the old Main server. If this is not done the new Main server will
alarm when the old Main server does not register. See
Main server
12. Verify that the correct translations are present for all ESS servers with the change
system-parameters ess command.
13. Disconnect, if connected, the old Main server from the LAN/WAN.
14. Connect the new Main server(s) to the LAN/WAN.
15. At any existing ESS server(s), verify that they are connected to the LAN/WAN.
16. At each ESS server specify:
a. The IP address of a CLAN controlled by the new Main server.
b. The IP address(es) of the new Main server.
Changing the address of the Main server on the ESS server does not require a reset
system 4, nor does it do one automatically.
For more information see
page 119
17. Verify that each ESS server registers with the Main server and translations are updated.
a. status ess clusters Verify that the Main server (this server) is shown and that all
ESS servers register and translations are updated. Periodically repeat this command
until all ESS servers are registered and updated.
136 Avaya Enterprise Survivable Servers (ESS) Users Guide
media servers release the busy out of the standby server using the
on page 122 for greater detail.
Configuring the Main server and each ESS server on
Administering ESS server on the