Ipp - Ricoh BP20N User Manual

IPP

1
2
3
4
5
6
7
8
Page 4-10
Use these instructi ons to setup IPP using BP20N.
NOTE: The HTTP settings for the device will have been setup when completing the
Enabling BP20N section.
To complete the installation of the device, perform these steps:
Enable BP20N (see "Enabling Internet Services" on page 4-5).
At the BP20N Home Page for the BP20N, select the [Network Administrator] tab.
Click IPP menu in the left frame
Check the IPP General Configuration details are correct. If any of the details of
IPP General are incorrect then enter the correct information.
Click the [Apply] button to implement any changes.
Click IPP Security link under the top menu.
Check the IPP Security details are correct. If any of the details of IPP Security are
incorrect then enter the correct information.
Click the [Apply] button to implement any changes.
NOTE: Click the [Reset] button to cancel any changes made and return to the
previous values.
System Administration Guide