Ricoh BP20N User Manual page 147

A.6
P F
RINTING ROM
Config Tab
You can configure various printer features.
• Emulation selects the emulation for printing a document. The
factory default is Auto.
• Power Save determines the length of time the printer waits
after a job is printed before it goes to a reduced power state. If
the printer is used frequently, select OFF which keeps the printer
ready to print with the minimum warm-up time. This uses more
power to keep the printer warm and ready to print.
• Auto Continue determines what action the printer should take if
the Multi-Purpose Tray is empty when a manual feed print job is
sent to the printer. If it is checked, the printer will pick up the
paper from the tray 1 after fifteen seconds. Otherwise, the
printer will wait for you to load paper in the Multi-Purpose Tray.
• Jam Recovery determines what action the printer should take
when a paper jam occurs. If it is unchecked, the printer does not
reprint a page that has jammed. If it is checked, the printer
keeps the image in memory for a printed page until the printer
signals that the page has successfully printed. The printer
reprints all jammed pages.
• Toner save determines the toner quantity the printer should use
when printing. If it is checked, the printer conserves toner when
printing. The default value is unchecked, which provides 100%
usage.
• Auto Clean Drum makes the printer print out a cleaning sheet
which clean the drum inside the toner cartridge automatically
every 500 print pages. This feature activates as a default
depending on the country.
DOS A
PPLICATIONS