Using Web Image Monitor Dsm520Pf/Ac122/Ac205; Introduction - Ricoh BP20N User Manual

Using Web Image Monitor DSm520pf/AC122/AC205

Introduction

Web Image Monitor DSm520pf/AC122/AC205 uses the embedded HTTP Server on the DSm520pf/AC122/AC205
to allow communication with the DSm520pf/AC122/AC205 if you have a Web Browser with access to the
Internet or Intranet. By entering the IP Address of the DSm520pf/AC122/AC205 as the URL (Universal
Resource Locator)in the Browser, direct access to the DSm520pf/AC122/AC205 is available.
NOTE: Microsoft Internet Explorer version 4.x or later should be used. Other
browsers may work, but could produce unexpected results.
Many of the selections and settings needed to install DSm520pf/AC122/AC205 on a network
can be made using Internet Services, eliminating steps that would otherwise need to be
performed at the DSm520pf/AC122/AC205 Control Panel.
Many of the features available within Internet Services will require an admin user name and
password. A user will only be prompted for an admin name and password once in a single
browser session.
Before the Internet Services feature can be used for installing DSm520pf/AC122/AC205 on a
network it must be enabled. There are two stages required to enable Internet Services:
NOTE: When making more than one configuration change please complete all the
changes in one go and then carry out a reboot.
System Administration Guide
Network Communication Setup
This requires the DSm520pf/AC122/AC205 to be setup for Internet Services.
Enable Internet Services
Make settings to the appropriate network
Page 3-3