Ricoh BP20N User Manual page 216

IPP
Use these instructions to setup IPP using Web Image Monitor DSm520pf/AC122/AC205.
NOTE: The HTTP settings for the device will have been setup when completing the
Enabling Web Image Monitor DSm520pf/AC122/AC205 section.
To complete the installation of the device, perform these steps:
Enable Web Image Monitor (see "Enabling Internet Services" on page 3-5).
1
At the Web Image Monitor Home Page for the DSm520pf/AC122/AC205, select the [Network
2
Settings] tab.
In the Network Settings, select [[Raw TCP/IP, LPR, IPP].
3
Select the checkbox to enable IPP.
4
Check the IPP Configuration details are correct. If any of the details are incorrect then
enter
In the IPP tab, configure the parameters.
Printer URI: Enter the URL of the printer using the following format:
Click the [Apply] button to implement any changes.
5
NOTE: Click the [Undo] button to cancel any changes made and return to the
previous values.
Page 3-16
the required configuration details in the appropriate boxes.
ipp://the IP address of the printer or http://the IP address of the printer:631
(Ex:ipp://168.10.17.82 or http://168.10.17.82:631) 631 is the IPP port number.
• Printer Name: Enter the network printer's name to use with the IPP printing.
• Operator message: Enter the printer information for printer users.
• Printer Location: Enter the name of the location where the printer is physically
located.
• Printer Information: Enter additional information about the printer.
• Multiple Operation Timeout: Enter the time the printer ends a print job. When
there is no incoming data after the specified number of seconds, the printer ends
the reception.
• Time to Keep Jobs in History: Set the length of time the IPP printer keeps the job
information.
System Administration Guide