Attaching And Removing The Seat; Attaching The Leg Lever To The Low Pulley Station; Adjusting The Leg Press Plate - Weider Wedier Pro 9635 User Manual

ATTACHING AND REMOVING THE SEAT

40
13
36
To attach the Seat (13), set the bracket on the Front
Seat Frame (36) onto the indicated pins on the Front
Upright (42). Attach the Seat Frame to the Front
Upright with the M8 x 70mm Carriage Bolt (14) and
the Seat Knob (40).
42
14
For some exercises, the Seat (13) must be removed.
First, make sure that the chain is not attached to the
leg lever. Next, remove the Seat Knob (40) and the
M8 x 70mm Carriage Bolt (14) from the Front Seat
Frame (36). Lift the Seat Frame off the Front Upright
(42).
ATTACHING THE LEG LEVER TO THE LOW
PULLEY STATION
To use the Leg Lever (29), the seat must be attached
to the front upright (see ATTACHING AND REMOV-
29
53
ING THE SEAT above).
52
35
Attach one end of the Chain (52) to the Low Cable
(23) with a Cable Clip (53). Attach the other end of
53
the Chain to the Eyebolt (35) with a Cable Clip.
23

ADJUSTING THE LEG PRESS PLATE

Remove the Press Pin (97) from the Leg Press Plate
95
Welded
(95) and the Leg Press Arm (96).
Tube
Align the welded tubes on the Leg Press Plate (95)
with the desired set of holes in the Leg Press Arm
(96). Re-insert the Press Pin (97) through the welded
97
tubes on Leg Press Plate and the holes in the Leg
Press Arm.
96
23