Attaching/Removing Seat; Attaching Leg Lever To Low Pulley; Weight Resistance Chart - Weider WESY85104 User Manual

ATTACHING AND REMOVING THE SEAT
Set the bracket on the Seat Frame (36) onto the indi-
cated pins on the Front Upright (42). Attach the Seat
Frame to the Front Upright with the 5/16" x 2 3/4"
Carriage Bolt (14) and the Seat Knob (40).
For some exercises, the Seat (13) must be removed.
First, be sure that the chain is not attached to the leg
lever. Next, remove the Seat Knob (40) and the 5/16"
x 2 3/4" Carriage Bolt (14) from the Seat Frame (36).
Lift the Seat Frame off the Front Upright (42).
ATTACHING THE LEG LEVER TO THE LOW
PULLEY STATION
To use the Leg Lever (29), the seat must be attached
to the front upright (see ATTACHING AND REMOV-
ING THE SEAT above).
Attach one end of the Chain (52) to the Short Cable
(58) with a Cable Clip (53). Attach the other end of
the Chain to the Eyebolt (35) with a Cable Clip.

WEIGHT RESISTANCE CHART

This chart shows the approximate weight resistance at each station. "Top" refers to the 6.5 lb. top weight. The
other numbers refer to the 12.5 lb. weight plates. Weight resistance shown for the butterfly arm station is for
each butterfly arm.
WEIGHT PRESS ARM
PLATES (lbs.)
Top 20
1 45
2 70
3 99
4 128
5 153
6 184
The actual resistance at each weight station may vary due to differences in individual weight plates, as well as
friction between the cables, pulleys, and weight guides.
BUTTERFLY ARM LEG LEVER
(lbs.)
10
22
33
42
48
60
69
18
40
42
14
52
53
58
HIGH PULLEY
(lbs.) (lbs.)
15 14
36 28
54 44
75 60
96 72
115 90
137 103
36
13
29
35
LOW PULLEY
(lbs.)
24
54
82
115
147
175
209