Weider Wedier Pro 9635 User Manual page 10

12. Attach the Press Arm (46) to one side of the
Press Frame (17) with two M8 x 63mm Bolts
(22) and two M8 Nylon Locknuts (3).
Assemble the other Press Arm (46) in the
same manner.
13. Identify the Right Arm (48) and the Left Arm
(47). Note the position of the welded bracket
on each Arm. Arm identification is very
important for step 14.
Attach a "V"-pulley (50) and a Long Cable
Trap (31) to the Right Arm (48) with an M10 x
57mm Bolt (86) and an M10 Nylon Locknut
(21). Do not tighten the Locknut yet.
Attach a "V"-pulley (50) and a Long Cable
Trap (31) to the Left Arm (47) in the same
manner.
14. Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle.
Note: Be careful not to confuse the Right
Arm with the Left Arm (47); refer to step 13
to identify the Right Arm. Make sure that
the upper end of the Right Arm is behind
the indicated bracket on the Top Frame
(55).
Tap two 25mm Retainers (69) and a 25mm
Round Cover Cap (70) onto the axle. Make
sure that the teeth on the Retainers bend
toward the Round Cover Cap, as shown in
the inset drawing.
Attach the Left Arm (47) in the same way.
Wet the lower end of the Right and Left Arms
(47, 48) with soapy water. Slide a 254mm Pad
(45) onto the lower end of each Arm.
12
46
13 86
31
50
Welded
Brackets
48
14
48
45
10
46
22
3
17
31
50
47
21
Bracket
55
Lubricate
Axle
69
45
70
Axle
69
47
70