Troubleshooting And Maintenance; Tightening The Cables - Weider Wedier Pro 9635 User Manual

TROUBLESHOOTING AND MAINTENANCE

Inspect and tighten all parts each time you use the weight system. Replace any worn parts immediately. The
weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is
slack in the cables before resistance is felt, the cables should be tightened. If any slack is felt when using the
front weight stack, both the High Cable (58) and the Low Cable (23) will need to be tightened. If any slack is felt
when using the rear weight stack, both the Military Press Cable (72) and the Leg Press Cable (99) will need to
be tightened.
To tighten the cables, insert the weight pin into the middle of
the weight stack. Slack can be removed from these cables
several ways:
• See drawing 1. Tighten the M8 Nylon Locknut (3) that
connects the end of the Low Cable (23) to the Long "U"-
bracket (57).
The Leg Press Cable (99) can be tightened in the same
manner.
• See drawing 1. Move the 90mm Pulley (15) to the other
hole in one of the Long "U"-brackets (57). Remove the
M10 Nylon Locknut (21) and the M10 x 47mm Bolt (12)
from the Cable Trap (66), Pulley, and Long "U"-bracket.
Reattach the Pulley and Cable Trap. Make sure that the
Cable Trap is in the proper position and that the Cable
and Pulley move smoothly.
The other Long "U"-bracket (57) can be adjusted in the
same manner.
• See drawing 2. Tighten the M8 Nylon Locknut (3) that
connects the end of the High Cable (58) to the Small "U"-
bracket (71).
The Military Press Cable (72) can be tightened in the
same manner.
See Drawing 3. If additional slack is felt while using the
•
Leg Press Arm (96), then the end of the Leg Press Cable
(99) must be moved to the next hole in the Rear Seat
Frame (100). Remove the M8 x 74mm Shoulder Bolt
(103), the M10 Washer (9), the end of the Cable, the
13mm x 6mm Spacer (104), and the M8 Nylon Locknut (3)
from the Rear Seat Frame. Reattach the Bolt, the Washer,
the Spacer, the end of the Cable, and the Nylon Locknuts
to the next hole in the Rear Seat Frame.
Do not overtighten the cables. The top weight will be lifted off the weight stack. If a cable tends to slip
off the pulleys often, it may have become twisted. Remove the cable and re-install it. If the cables need to
be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.
1
66
2
72
71
3
3
25
15
21
12
57
3
23 or 99
58
71
3
96
103
9
100
99
104
3