Arm Assembly - Weider Wedier Pro 9635 User Manual

9. Attach the upper ends of the Short Weight
Guides (73) to the Top Frame (55) with an M8 x
150mm Bolt (60), two 13mm x 19mm Spacers
(61), and an M8 Nylon Locknut (3).
Attach the upper ends of the Long Weight
Guides (62) to the Top Frame (55) with an M8 x
150mm Bolt (60), two 13mm x 19mm Spacers
(61), and an M8 Nylon Locknut (3).
10. Locate and open the parts packet labeled

"ARM ASSEMBLY."

Lubricate an M10 x 83mm Bolt (67). Attach the
Leg Press Arm (96) to the Stabilizer (5) with the
Bolt and an M10 Nylon Locknut (21). Do not
overtighten the Locknut; the Leg Press Arm
must be able to pivot freely.
Align the welded tubes on the Leg Press Plate
(95) with a set of holes in the Leg Press Arm
(96). Attach the Leg Press Plate to the Leg
Press Arm with the Press Pin (97).
11. Press a 25mm x 22mm Plastic Bushing (90)
onto each welded spacer on the Press Frame
(17). Slide the Press Frame into place onto the
Base (4). Note: This will be a tight fit. The
Plastic Bushings should fit on each end of
the indicated tube in the Base. Make sure
that the holes are on the side shown.
Lubricate the M10 x 196mm Bolt (59). Attach
the Press Frame (17) to the Base (4) with the
Bolt and an M10 Nylon Locknut (21).
9
61
60
73
10
96
5
11
21
4
Tube
9
61
3
3
55
60
73
62
95
Welded
Tube
97
21
67—Lubricate
Holes must
17
be on this
side
59
Lubricate
Welded Spacers
90