Attaching/Removing Seat; Attaching Leg Lever To Low Pulley; Weight Resistance Chart - Weider 8530 User Manual

ATTACHING AND REMOVING THE SEAT
To attach the Seat (13), set the bracket on the Seat
Frame (36) onto the indicated pins on the Front
Upright (42). Attach the Seat Frame to the Front
Upright with the 5/16" x 2 3/4" Carriage Bolt (14) and
the Seat Knob (40).
For some exercises, the Seat (13) must be removed.
First, be sure that the chain is not attached to the leg
lever. Next, remove the Seat Knob (40) and the 5/16"
x 2 3/4" Carriage Bolt (14) from the Seat Frame (36).
Lift the Seat Frame off the Front Upright (42).
ATTACHING THE LEG LEVER TO THE LOW
PULLEY STATION
To use the Leg Lever (29), the seat must be attached
to the front upright (see ATTACHING AND REMOV-
ING THE SEAT above.)
Attach one end of the Chain (52) to the Short Cable
(23) with a Cable Clip (53). Attach the other end of
the Chain to the Eyebolt (35) with a Cable Clip.

WEIGHT RESISTANCE CHART

This chart shows the approximate weight resistance at each station. "Top" refers to the 6.5 lb. top weight. The
other numbers refer to the 12.5 lb. weight plates. The butterfly arm resistance listed is the resistance for each
butterfly arm.
WEIGHT
PRESS ARM
PLATES (lbs.)
Top 20
1 45
2 70
3 99
4 128
5 153
6 184
7 204
8 247
BUTTERFLY ARM LEG LEVER
(lbs.) (lbs.)
10
22
33
42
48
60 115
69 137
79 146
91 176
14
23
HIGH PULLEY
(lbs.)
15 14
36 28
54 44
75 60
96 72
90
103
126
138
18
40
13
36
42
29
53
52
35
53
LOW PULLEY SQUAT ARM
(lbs.) (lbs.)
24 31
54 52
82 75
115 101
147 114
175 136
209 157
223 174
269 194