Weider Wedier Pro 9635 User Manual page 13

22. See the inset drawing. Route the High Cable
(58) under a 90mm Pulley (15). Attach the
Pulley and a Cable Trap (66) to the upper hole
in a Long "U"-bracket (57) with an M10 x
47mm Bolt (12) and an M10 Nylon Locknut
(21). Make sure that the Cable is in the
groove of the Pulley and that the Cable and
Pulley move smoothly.
23. Wrap the High Cable (58) over a 90mm Pulley
(15). Attach the Pulley to the bracket on the
Top Frame (55) with an M10 x 47mm Bolt (12)
and an M10 Nylon Locknut (21). Make sure
that the Cable is in the groove of the Pulley
and that the Cable and Pulley move
smoothly.
24. Locate the Low Cable (23). Route the Low
Cable under the 90mm Reinforced Pulley
(106). Attach the Pulley and the 16mm x 14mm
Spacer (7) to the lower hole in the Press
Frame (17) with an M10 x 92mm Bolt (88), an
M10 Washer (9), and an M10 Nylon Locknut
(21). Make sure that the parts are assem-
bled in the order shown, that the end of the
Cable with the ball is on the indicated side
of the Press Frame, and that the Cable is
between the Pulley and the crossbar on the
Press Frame.
22
66
15
21
57
23
21
24
Crossbar
13
58
15
12
58
57
58
15
Bracket
55
9
88
17
106
7
21
Ball
12
23