Weider Wedier Pro 9635 User Manual page 17

33. See inset drawing A. Route the Military
Press Cable (72) under a 90mm Pulley (15).
Attach the Pulley and a Cable Trap (66) to the
upper hole in the Long "U"-bracket (57) with
an M10 x 47mm Bolt (12) and an M10 Nylon
Locknut (21). Make sure that the Cable is in
the groove of the Pulley and that the Cable
and Pulley move smoothly.
See inset drawing B. Slide an M10 Washer
(9) onto an M8 x 74mm Shoulder Bolt (103).
Insert the Bolt through the Pivot Arm (101)
from the indicated side. Slide a 13mm x 6mm
Spacer (104) and the end of the Military Press
Cable (72) onto the end of the Bolt. Thread
an M8 Nylon Locknut (3) onto the Bolt. Make
sure that the end of the Cable can pivot
easily.
34. Locate the Leg Press Cable (99). Attach the
end of the Leg Press Cable to the Long "U"-
bracket (57) with an M8 Nylon Locknut (3)
and an M8 Washer (8). Do not completely
tighten the Locknut. It should be threaded
onto the end of the Cable so that only two
threads are showing past the Locknut, as
shown in the inset drawing.
Wrap the Leg Press Cable (99) under a
90mm Pulley (15). Attach the Pulley to the
Leg Press Upright (56) with the M10 x 90mm
Bolt (16), an M10 Washer (9), and an M10
Nylon Locknut (21). The ball on the Cable
must be on the indicated side of the
Pulley. Make sure that the Cable and
Pulley move smoothly and that the Cable
is between the Pulley and the welded rod.
33
57
15
72
34
3
8
16
99
3
57
99
17
72 15
21
66
57
12
103
101
9
104
72
57
56
Ball
15
9
21
Welded
Rod
A
B
3