Syslog Server Setup - ZyXEL Communications MGS-3712/MES-3728 User Manual

36.3 Syslog Server Setup

Click Management > Syslog > Syslog Server Setup to view the screen as
shown next. Use this screen to configure a list of external syslog servers.
Figure 183 Management > Syslog > Syslog Server Setup
The following table describes the labels in this screen.
Table 116 Management > Syslog > Syslog Server Setup
LABEL
Active
Server Address
Log Level
Add
Cancel
Clear
Index
Active
IP Address
Log Level
Delete
Cancel
MES-3728 User's Guide
DESCRIPTION
Select this check box to have the device send logs to this syslog server.
Clear the check box if you want to create a syslog server entry but not
have the device send logs to it (you can edit the entry later).
Enter the IP address of the syslog server.
Select the severity level(s) of the logs that you want the device to send
to this syslog server. The lower the number, the more critical the logs
are.
Click Add to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to return the fields to the factory defaults.
This is the index number of a syslog server entry. Click this number to
edit the entry.
This field displays Yes if the device is to send logs to the syslog server.
No displays if the device is not to send logs to the syslog server.
This field displays the IP address of the syslog server.
This field displays the severity level of the logs that the device is to send
to this syslog server.
Select an entry's Delete check box and click Delete to remove the
entry.
Click Cancel to begin configuring this screen afresh.
Chapter 36 Syslog
331