Configuring Snmp Trap Group - ZyXEL Communications MGS-3712/MES-3728 User Manual

Chapter 34 Access Control
Table 108 Management > Access Control > SNMP (continued)
LABEL
Privacy
Apply
Cancel

34.3.5 Configuring SNMP Trap Group

Click Management > Access Control > SNMP > Trap Group to view the screen
as shown. Use the Trap Group screen to specify the types of SNMP traps that
should be sent to each SNMP manager.
Figure 170 Management > Access Control > SNMP > Trap Group
314
DESCRIPTION
Specify the encryption method for SNMP communication from this user.
You can choose one of the following:
• DES - Data Encryption Standard is a widely used (but breakable)
method of data encryption. It applies a 56-bit key to each 64-bit
block of data.
• AES - Advanced Encryption Standard is another method for data
encryption that also uses a secret key. AES applies a 128-bit key to
128-bit blocks of data.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MES-3728 User's Guide