Remote Management - ZyXEL Communications MGS-3712/MES-3728 User Manual

Chapter 34 Access Control
later). Click Management > Access Control > Service Access Control to view
the screen as shown.
Figure 179 Management > Access Control > Service Access Control
The following table describes the fields in this screen.
Table 111 Management > Access Control > Service Access Control
LABEL
Services
Active
Service
Port
Timeout
Apply
Cancel

34.10 Remote Management

Click Management > Access Control > Remote Management to view the
screen as shown next.
324
DESCRIPTION
Services you may use to access the Switch are listed here.
Select this option for the corresponding services that you want to allow to
access the Switch.
For Telnet, SSH, FTP, HTTP or HTTPS services, you may change the default
service port by typing the new port number in the Server Port field. If you
change the default port number then you will have to let people (who wish
to use the service) know the new port number for that service.
Type how many minutes a management session (via the web configurator)
can be left idle before the session times out. After it times out you have to
log in with your password again. Very long idle timeouts may have security
risks.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the Save
link on the top navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MES-3728 User's Guide