Configuring Snmp - ZyXEL Communications MGS-3712/MES-3728 User Manual

Chapter 34 Access Control

34.3.4 Configuring SNMP

Click Management > Access Control > SNMP to view the screen as shown. Use
this screen to configure your SNMP settings.
Figure 169 Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 108 Management > Access Control > SNMP
LABEL
General Setting
Version
Get Community
312
DESCRIPTION
Use this section to specify the SNMP version and community (password)
values.
Select the SNMP version for the Switch. The SNMP version on the Switch
must match the version on the SNMP manager. Choose SNMP version 2c
(v2c), SNMP version 3 (v3) or both (v3v2c).
Note: SNMP version 2c is backwards compatible with SNMP
version 1.
Enter the Get Community string, which is the password for the
incoming Get- and GetNext- requests from the management station.
The Get Community string is only used by SNMP managers using
SNMP version 2c or lower.
MES-3728 User's Guide