Arp Inspection Vlan Status - ZyXEL Communications MGS-3712/MES-3728 User Manual

Table 80 ARP Inspection Status (continued)
LABEL
Delete
Cancel
Change Pages

26.6.1 ARP Inspection VLAN Status

Use this screen to look at various statistics about ARP packets in each VLAN. To
open this screen, click Advanced Application > IP Source Guard > ARP
Inspection > VLAN Status.
Figure 129 ARP Inspection VLAN Status
The following table describes the labels in this screen.
Table 81 ARP Inspection VLAN Status
LABEL
Show VLAN range
Enabled VLAN
Selected VLAN
Apply
VID
Received
Request
MES-3728 User's Guide
DESCRIPTION
Select this, and click Delete to remove the specified entry.
Click this to clear the Delete check boxes above.
Click Previous or Next to show the previous/next screen if all
status information cannot be seen in one screen.
DESCRIPTION
Use this section to specify the VLANs you want to look at in the
section below.
Select this to look at all the VLANs on which ARP inspection is
enabled in the section below.
Select this to look at all the VLANs in a specific range in the
section below. Then, enter the lowest VLAN ID (Start VID) and
the highest VLAN ID (End VID) you want to look at.
Click this to display the specified range of VLANs in the section
below.
This field displays the VLAN ID of each VLAN in the range specified
above.
This field displays the total number of ARP packets received from
the VLAN since the Switch last restarted.
This field displays the total number of ARP Request packets
received from the VLAN since the Switch last restarted.
Chapter 26 IP Source Guard
253