Table of Contents
Advertisement
Table 29 Advanced Application > Spanning Tree Protocol > MRSTP (continued)
LABEL
Tree
Apply
Cancel
13.7 Multiple Rapid Spanning Tree Protocol
Status
Click Advanced Application > Spanning Tree Protocol in the navigation panel
to display the status screen as shown next. See
more information on MRSTP.
Note: This screen is only available after you activate MRSTP on the Switch.
Figure 74 Advanced Application > Spanning Tree Protocol > Status: MRSTP
The following table describes the labels in this screen.
Table 30 Advanced Application > Spanning Tree Protocol > Status: MRSTP
LABEL
Configuration
Tree
Bridge
Bridge ID
MES-3728 User's Guide
DESCRIPTION
Select which STP tree configuration this port should participate in.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Click Configuration to specify which STP mode you want to activate.
Click MRSTP to edit MRSTP settings on the Switch.
Select which STP tree configuration you want to view.
Root refers to the base of the spanning tree (the root bridge). Our
Bridge is this switch. This Switch may also be the root bridge.
This is the unique identifier for this bridge, consisting of bridge priority
plus MAC address. This ID is the same for Root and Our Bridge if the
Switch is the root switch.
Chapter 13 Spanning Tree Protocol
Section 13.1 on page 125
for
139
Advertisement
Table of Contents
Troubleshooting
